Permanent lighting is a carpentry job with an electrical job inside it. Most of what decides whether you still like it in five years is settled at the roof edge, on the day the van turns up.
Call 402-810-3973
Every penetration sealed at the moment it is made, which is where installs fail at year five.
One visit, and nothing left on your property when it is done.
Every scene switched through with you, so nobody is handed an app they have not used.
Before anything is drilled
Measured again off the ladder before a single hole is drilled.
The channel goes on
Extruded aluminum, screwed to the fascia on a fixed pitch, sealed as each fixing is driven.
Sealing, as we go
Sealant on the screw as it is driven, rather than a pass along the run at the end of the day.
Before we leave
Diffuser clipped in, then every scene walked through with you.
Drawn to what we actually install: the channel into the fascia board, the conductor inside the channel, the diffuser facing down. The same join, finished, in more detail.
The channel is the easy part. Five other decisions get made on your property that day, and every one of them is a thing you would only notice if somebody got it wrong.
We site it somewhere serviceable and dry, and not the middle of your garage wall. You will know where it is before we leave.
Inside the channel where it can be, then the shortest concealed route. Nothing crosses a soffit in the open.
We work the zoning out at the measure and wire it on install day. Adding one afterwards is a wiring job, not an app setting.
Standoffs and pads, beds walked around, gutters not leaned on.
Offcuts, screws, packaging and the aluminum filings from every cut, off site with us.
One crew and a walkthrough of every scene before anybody leaves.
The step
How we do it
The usual way
How we do it
Measured and designed standing on your own driveway, against your own elevation and your own roof shape.
The usual way
Quoted from the driveway at two in the afternoon, off a photograph and a rough count.
How we do it
Every penetration sealed at the moment it is made, rather than bridged over later.
The usual way
A pass along the whole run at the end of the day, bridging holes that have already taken dust.
How we do it
Roofline, soffit, landscape and anything over the patio all answer to the same app, because they go in on the same system.
The usual way
The roofline on one app and the landscape lighting on another, or on a plug by the back door.
How we do it
Your everyday setting chosen first, then the scenes you actually asked for, saved with you holding the phone.
The usual way
Handed over with the factory presets and an app nobody opens twice.
The right-hand column describes practices that are common in this trade and that we have chosen not to use. It is not a claim about any particular company.
One visit and one piece of paper. That is the whole of it.
The consultation
About an hour, and no charge for the visit. It has its own page because it is the part people ask about most.
The written quote
One number for the whole scope, itemized by elevation, hardware and zone, unchanged on install day.
The covenant
Worth reading the lighting clause before anything is ordered, if your neighborhood has one.
What happens after we leave, which is the part you will actually judge us on.
A section goes dark
Almost always a driver or one bad connection rather than the whole run. We come out and fix that section.
You want another zone
The back elevation, the pergola, the beds. It ties into the controller you already have.
Something we installed fails
You call the number on this site and one of the two owners answers it.
We measure on site, design it with you, and hand you a written quote. If you decide against it, you’ve lost an hour and gained a plan.
Not ready for a visit? Read compare the brands we are asked about.
Or call 402-810-3973. Same-day reply, most days.
